Modelling, Simulation and Validation for a Multimode Double-Pendulum Overhead Crane

Authors

  • Sharifah Yuslinda Syed Hussien Universiti Teknikal Malaysia Melaka
  • Hazriq Izzuan Jaafar Universiti Teknikal Malaysia Melaka
  • Rozaimi Ghazali Universiti Teknikal Malaysia Melaka
  • Mariam Md Ghazaly Universiti Teknikal Malaysia Melaka
  • Mohd Khairul Azizat Johari Johor Port Berhad
  • Liyana Ramli Universiti Sains Islam Malaysia

Keywords:

Double-pendulum, Lagrange’s method, Overhead crane, Payload hoisting, System modelling

Abstract

This paper focuses on the modelling of a multimode double-pendulum overhead crane (MDPOC) system which generates double-pendulum phenomenon. The MDPOC is far more complex than those of single-pendulum overhead cranes due to the additional degree of freedom, greater nonlinearities, and stronger internal couplings especially involving two or more oscillation frequencies with multimode dynamic effects. More interestingly, two scenarios under fixed and varying cable lengths (payload hoisting) are considered which are closer to the real practical crane. The dynamic crane models are derived using Lagrange’s method. Simulations using the Matlab/Simulink block diagram, as well as experiments on a laboratory overhead crane are used to verify and validate the accuracy of MDPOC mathematical modelling. The simulation and experimental results demonstrate the superiority and similar pattern of the trolley position, hook oscillation and payload oscillation under fixed and varying cable lengths that verified the mathematical modelling of MDPOC. It is beneficial for crane operators to understand the dynamic model of MDPOC and useful for future analysis of controller implementation with confidence by researchers.

References

[1] S. Zode, S. Sheshank, S. Challa, A. C. Mahato and J. P. Tripathi, Modelling and motion analysis of an automotive seating track using finite element analysis, Applications of Modelling and Simulation, 8, 2024, 40-47.

[2] G. D’Ago, M. Selvaggio, A. Suarez, F. J. Ganan, L. R. Buonocore, M. Di Castro, V. Lippiello, A. Ollero and F. Ruggiero, Modelling and identification methods for simulation of cable-suspended dual-arm robotic systems, Robotics and Autonomous System, 175, 2024, 104643.

[3] Y. Zhang, M. Li and C. Yang, Robot learning system based on dynamic movement primitives and neural network, Neurocomputing, 451, 2021, 205-214.

[4] K. Katsampiris-Salgado, K. Haninger, C. Gkrizis, N. Dimitropoulos, J. Kruger, G. Michalos and S. Makris, Collision detection for collaborative assembly operations on high-payload robots, Robotics and Computer-Integrated Manufacturing, 87, 2024, 102708.

[5] H. I. Jaafar, Z. Mohamed, J. J. Jamian, A. F. Z. Abidin, A. M. Kassim and Z. A. Ghani, Dynamic behaviour of a nonlinear gantry crane system, Procedia Technology, 11, 2013, 419-425.

[6] M. R. Mojallizadeh, B. Brogliato and C. Prieur, Modeling and control of overhead cranes: A tutorial overview and perspectives, Annual Reviews in Control, 56, 2023, 100877.

[7] M. M. Bello, Z. Mohamed, M. Ö. Efe and H. Ishak, Modelling and dynamic characterisation of a double-pendulum overhead crane carrying a distributed-mass payload, Simulation Modelling Practice and Theory, 134, 2024, 102953.

[8] K. H. Umer and H. Shah, Control Dynamics and Control of Industrial Cranes, Singapore: Springer, 2019.

[9] E. M. Abdel-Rahman, A. H. Nayfeh and Z. N. Masoud, Dynamics and control of cranes: A review, Journal of Vibration and Control, 9, 2003, 863-908.

[10] L. Ramli, Z. Mohamed, A. M. Abdullahi, H. I. Jaafar and I. M. Lazim, Control strategies for crane systems: A comprehensive review, Mechanical Systems and Signal Processing, 95, 2017, 1-23.

[11] M. Hussein and T. Zayed, Crane operations and planning in modular integrated construction: Mixed review of literature, Automation in Construction, 122, 2021, 103466.

[12] N. Sun, T. Yang, Y. Fang, Y. Wu and H. Chen, Transportation control of double-pendulum cranes with a nonlinear quasi-PID scheme: Design and experiments, IEEE Transactions on System, Man, and Cybernetics: Systems, 49, 2019, 1408-1418.

[13] Z. Tian, L. Yu, H. Ouyang and G. Zhang, Transportation and swing reduction for double-pendulum tower cranes using partial enhanced-coupling nonlinear controller with initial saturation, ISA Transactions, 112, 2021, 122-136.

[14] H. D. Tho, N. Uchiyama and K. Terashima, Resonance-based tossing control for bulk materials transportation of an overhead crane, IEEE Transactions on Industrial Electronics, 68, 2021, 609-621.

[15] S. Sadeghi, N. Soltanmohammadlou and P. Rahnamayiezekavat, A systematic review of scholarly works addressing crane safety requirements, Safety Science, 133, 2021, 105002.

[16] S. R. Mohandes, S. Abdelmageed, S. Hem, J. S. Yoo, T. Abhayajeewa and T. Zayed, Occupational health and safety in modular integrated construction projects: The case of crane operations, Journal of Cleaner Production, 342, 2022, 130950.

[17] N. Sun, Y. Fang, H. Chen and B. Lu, Amplitude-saturated nonlinear output feedback antiswing control for underactuated cranes with double-pendulum cargo dynamics, IEEE Transactions on Industrial Electronics, 64, 2017, 2135-2146.

[18] A. Mohammed, H. Altuwais and K. Alghanim, An optimized shaped command of overhead crane nonlinear system for rest-to-rest maneuver, Journal of Engineering Research, 11, 2023, 548-554.

[19] N. Sun, Y. Wu, Y. Fang and H. Chen, Nonlinear antiswing control for crane systems with double-pendulum swing effects and uncertain parameters: Design and experiments, IEEE Transactions on Automation Science and Engineering, 15, 2018, 1413-1422.

[20] A. M. Abdullahi, Z. Mohamed, H. Selamat, H. R. Pota, M. S. Zainal Abidin and S. M. Fasih, Efficient control of a 3D overhead crane with simultaneous payload hoisting and wind disturbance: Design, simulation and experiment, Mechanical Systems and Signal Processing, 145, 2020, 106893.

[21] M. Li, H. Chen and R. Zhang, An input dead zones considered adaptive fuzzy control approach for double pendulum cranes with variable rope lengths, IEEE/ASME Transactions on Mechatronics, 27, 2022, 3385-3396.

[22] M. Li, H. Chen and Z. Li, Input-limited optimal control for overhead cranes with payload hoisting/lowering and double pendulum effects, Nonlinear Dynamics, 111, 2023, 11135-11151.

[23] D. Li, T. Xie, G. Li, J. Yao and S. Hu, Adaptive coupling tracking control strategy for double-pendulum bridge crane with load hoisting/lowering, Nonlinear Dynamics, 112, 2024, 8261-8280.

[24] S. Wang, W. Jin and W. Chen, A novel payload swing control method based on active disturbance rejection control for 3D overhead crane systems with time-varying rope length, Journal of the Franklin Institute, 361, 2024, 106707.

[25] H. Ouyang, B. Zhao and G. Zhang, Enhanced-coupling nonlinear controller design for load swing suppression in three-dimensional overhead cranes with double-pendulum effect, ISA Transactions, 115, 2021, 95-107.

[26] H. I. Jaafar, Z. Mohamed, M. A. Ahmad, N. A. Wahab, L. Ramli and M. H. Shaheed, Control of an underactuated double-pendulum overhead crane using improved model reference command shaping: Design, simulation and experiment, Mechanical Systems and Signal Processing, 151, 2021, 107358.

[27] S. Arabasi and Z. Masoud, Frequency-modulation input-shaping strategy for double-pendulum overhead cranes undergoing simultaneous hoist and travel maneuvers, IEEE Access, 10, 2022, 44954-44963.

[28] D. Qian and J. Yi, Hierarchical Sliding Mode Control for Under-Actuated Cranes, Berlin, Heidelberg: Springer, 2015.

[29] A. Talaeizadeh, M. Forootan, M. Zabihi and H. N. Pishkenari, Comparison of kane’s and lagrange’s methods in analysis of constrained dynamical systems, Robotica, 38, 2020, 2138-2150.

[30] M. M. Bello, Z. Mohamed, S. M. F. ur Rehman, W. A. Balogun, K. Aibek and S. Gamzat, Multi-mode input shapers for oscillation control of an overhead crane with distributed mass payload, Applications of Modelling and Simulation, 8, 2024, 191-200.

[31] M. Giacomelli, F. Padula, L. Simoni and A. Visioli, Simplified input-output inversion control of a double pendulum overhead crane for residual oscillations reduction, Mechatronics, 56, 2018, 37-47.

[32] H. Ouyang, J. Hu, G. Zhang, L. Mei and X. Deng, Sliding-mode-based trajectory tracking and load sway suppression control for double-pendulum overhead cranes, IEEE Access, 7, 2019, 4371-4379.

[33] B. Lu, Y. Fang and N. Sun, Enhanced-coupling adaptive control for double-pendulum overhead cranes with payload Hoisting and Lowering, Automatica, 101, 2019, 241-251.

Downloads

Published

20-10-2024

How to Cite

Syed Hussien, S. Y., Jaafar, H. I., Ghazali, R., Md Ghazaly, M., Johari, M. K. A., & Ramli, L. (2024). Modelling, Simulation and Validation for a Multimode Double-Pendulum Overhead Crane. Applications of Modelling and Simulation, 8, 261–271. Retrieved from https://www.ojs.arqiipubl.com/index.php/AMS_Journal/article/view/704

Issue

Vol. 8 (2024)

Section

Articles

License

Copyright (c) 2024 Sharifah Yuslinda Syed Hussien, Hazriq Izzuan Jaafar

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Authors who publish with this journal agree to the following terms:

Authors hold and retain copyright, and grant the journal right of first publication, with the work after publication simultaneously licensed under a Creative Commons Attribution 4.0 License CC BY that permits any use, reproduction and distribution of the work and article without further permission provided that the original work is properly cited.

Authors are permitted and encouraged to post their work online in institutional repositories, website and other social media before and after publication, as it can lead to productive exchanges, as well as earlier and greater citation of published work.

Most read articles by the same author(s)

Similar Articles

<< < 1 2 3 4 5 6 7 8 > >> 

You may also start an advanced similarity search for this article.