Studies on Hydraulic Pump Characteristics Through Experiment and Simulation in MATLAB Simscape

Authors

  • Muhammad Nizam Kamarudin Faculty of Electrical Technology and Engineering, Universiti Teknikal Malaysia Melaka (UTeM), Malaysia http://orcid.org/0000-0003-3476-3746
  • Sahazati Md Rozali Faculty of Electrical Technology and Engineering, Universiti Teknikal Malaysia Melaka (UTeM), Malaysia
  • Mohd Shahrieel Mohd Aras Faculty of Electrical Technology and Engineering, Universiti Teknikal Malaysia Melaka (UTeM), Malaysia
  • Mohd Hendra Hairi Faculty of Electrical Technology and Engineering, Universiti Teknikal Malaysia Melaka (UTeM), Malaysia
  • Lokman Abdullah Faculty of Industrial and Manufacturing Technology, Universiti Teknikal Malaysia Melaka Durian Tunggal (UTeM), Malaysia
  • Zairi Ismael Rizman School of Electrical Engineering, College of Engineering, Universiti Teknologi MARA, Dungun, Terengganu, Malaysia

Keywords:

Flow rate, Hydraulic power, Hydraulic pump, Matlab, Simscape

Abstract

Hydraulic pumps are the heart of hydraulic systems that convert electrical energy into mechanical energy. As the behavior of a specific type of hydraulic pump must be identified to cater to the pump's limits and operating range, precise pump selection for particular applications is a must. Hence, this paper presents the research findings on the characteristics of hydraulic pumps, focusing on pump parameters such as pump power, flow rate, and operating pressure. These parameters were evaluated under no-load operating conditions without actuators. The simulation setup is realized through Simscape on the MATLAB platform. The laboratory test rig exploits the advantages of Bosch Rexroth hydraulic pumps and other hydraulic components manufactured by the Rexroth group of companies. The findings from this research find a relationship between pump power, pressure, and flow rate. The simulation and experimental results showed good agreement with a very slight percentage difference, where the factors that contribute to the slight tolerance are thoroughly elaborated.

References

[1] V. Savic, D. Kneževic, D. Lovrec, M. Jocanovic and V. Karanovic, Determination of pressure losses in hydraulic pipeline systems by considering temperature and pressure, Journal of Mechanical Engineering, 55, 2009, 237-243.

[2] M. Papoutsidakis, A. Chatzopoulos, D. Papachristos and C. Drosos, Hydraulics and pneumatics: Operational characteristics and control for modern industry applications, International Journal of Computer Applications, 178(25), 2019, 31-40.

[3] R. Keith Mobley, 10 - Troubleshooting Hydraulic Systems, Book chapter in Fluid Power Dynamics, Butterworth-Heinemann, Newnes, 2000,171-177.

[4] Y. Song, D. Wang, H. Ren, J. Cai and B Jing, Research on hydraulic pump displacement control using PI and feed-forward compensation, Advances in Mechanical Engineering, 9(12), 2017, 1-8.

[5] L. Xu, H. Zhang, C. Wang, D. Ji, W. Shi, W. Lu and L. Lu, Hydraulic characteristics of axial flow pump device with different guide vane inlet angles, Frontiers in Energy Research, 10, 2022, 1-13.

[6] J. Kosibaa, Z. Tkáč, J. Jablonický, V. Shcherbak, L. Ganushchak-Yefimenko, M. Paumer, T. Bukoros, G. Čurgaliováa and M. Zachar, Experimental testing of the influence of the operating loading on the flow characteristics of hydraulic pump, Eksploatacja i Niezawodnosc - Maintenance and Reliability, 24(3), 2022, 583-589.

[7] W. Wan and W. Huang, Investigation on complete characteristics and hydraulic transient of centrifugal pump, Journal of Mechanical Science and Technology, 25(10), 2011, 2583-2590.

[8] M. Hao, S. Liu, G. Liu and H. Pan, Research on dynamic characteristics of hydraulic pump slipper with wear based on operational modal analysis, IEEE 6th Information Technology, Networking, Electronic and Automation Control Conference (ITNEC), Chongqing, China, 2023, 1098-1103.

[9] L. Shi, W. Zhang, H. Jiao, F. Tang, L. Wang, D. Sun and W. Shi, Numerical simulation and experimental study on the comparison of the hydraulic characteristics of an axial-flow pump and a full tubular pump, Renewable Energy, 153, 2020, 1455-1464.

[10] S. Fu, Y. Zheng, K. Kan, H. Chen, X. Han, X. Liang and X. Tian, Numerical simulation and experimental study of transient characteristics in an axial flow pump during start-up, Renewable Energy, 146, 2020, 1879-1887.

[11] A. R. Al-Obaidi and A. A. Mohammed, Numerical investigations of transient flow characteristic in axial flow pump and pressure fluctuation analysis based on the CFD technique, Journal of Engineering Science & Technology Review, 12(6), 2019, 70-79.

[12] A. R. Al-Obaidi, Evaluation and investigation of hydraulic performance characteristics in an axial pump based on CFD and acoustic analysis, Processes, 12(129), 2024, 1-37.

[13] R. Keith Mobley, 3 – Hydraulic Pumps (Book chapter), Fluid Power Dynamics, Butterworth-Heinemann, Newnes, 2000, 25-46.

[14] A. Dzhurabekov, J. Rashidov, A. Gazaryan, B. Kholbutaev, S. Mansurova and N. Tashmatov, Improving impeller and water flow section of vane pumps, IV International Scientific Conference in Construction Mechanics, Hydraulics and Water Resources Engineering (CONMECHYDRO), Tashkent, Uzbekistan, 363, 2022, 1-12.

[15] J. M. Bergada, S. Kumar, D. Ll. Davies and J. Watton, A complete analysis of axial piston pump leakage and output flow ripples, Applied Mathematical Modelling, 36(4), 2012, 1731-1751.

[16] O. Chiavola, E. Frattini, F. Palmieri, A. Fioravanti and P. Marani, On the efficiency of mobile hydraulic power packs operating with new and aged eco-friendly fluids, Energies, 16(5681), 2023, 1-16.

[17] H. Xu, W. Chen and W. Hu, Hydraulic transport flow law of natural gas hydrate pipeline under marine dynamic environment, Engineering Applications of Computational Fluid Mechanics, 14, 2020, 507-521.

Downloads

Published

01-11-2024

How to Cite

Kamarudin, M. N., Md Rozali, S., Mohd Aras, M. S., Hairi, M. H., Abdullah, L., & Rizman, Z. I. (2024). Studies on Hydraulic Pump Characteristics Through Experiment and Simulation in MATLAB Simscape. Applications of Modelling and Simulation, 8, 301–309. Retrieved from https://www.ojs.arqiipubl.com/index.php/AMS_Journal/article/view/634

Issue

Vol. 8 (2024)

Section

Articles

License

Copyright (c) 2024 Muhammad Nizam Kamarudin, Sahazati Md Rozali, Mohd Shahrieel Mohd Aras, Lokman Abdullah, Zairi Ismael Rizman

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Authors who publish with this journal agree to the following terms:

Authors hold and retain copyright, and grant the journal right of first publication, with the work after publication simultaneously licensed under a Creative Commons Attribution 4.0 License CC BY that permits any use, reproduction and distribution of the work and article without further permission provided that the original work is properly cited.

Authors are permitted and encouraged to post their work online in institutional repositories, website and other social media before and after publication, as it can lead to productive exchanges, as well as earlier and greater citation of published work.

Similar Articles

<< < 1 2 3 4 5 > >> 

You may also start an advanced similarity search for this article.